Default setting ( = )
Setting to will return all parameters to the standard values that were programmed at the factory.
⇒ See section 4.2.7.
Trip clear ( = )
Setting to initializes the past four sets of recorded error history data.
Cumulative operation time clear ( = )
Setting to resets the cumulative operation time to the initial value (zero).
Cumulative operation time clear ( = )
Setting to clears the trips when an format error occurs. But if the displayed, call us.
5
Save user setting parameters ( = )
Setting to saves the current settings of all parameters.
⇒ See section 4.2.8.
Load user setting parameters ( = )
Setting to loads parameter settings to (calls up) those saved by setting to .
⇒ See section 4.2.8.
Cumulative fan operation time record clear ( = )
Setting to resets the cumulative operation time to the initial value (zero).
Set this parameter when replacing the cooling fan, and so on.
When 3 is programmed, < will be displayed for a short time after setting and will then be erased
and displayed the original indication .. Trip history data will be cleared at this time.
The parameter does not change.
By setting to or , you can use parameters as your own default parameters.
E-14
E6581381