Toshiba TOSVERT VF-FS1 Instruction Manual page 55

4.2.1
All of the basic parameters can be set by the same step procedures.
[Steps in key entry for basic parameters]
4
Example of setting procedure (Changing the maximum frequency from 80Hz to 60Hz).
Key operated
After this,
How to set the basic parameters
Switches to the setting monitor mode.
MODE
Selects parameter to be changed.
Reads the programmed parameter
setting.
ENT
Changes the parameter setting.
Saves the changed value of the
ENT
parameter setting.
LED display

MODE


ENT


ENT
⇔
→Displays the same
ENT
programmed
parameter.
Displays the operation frequency (operation stopped).
(When standard monitor display selection = [Operation
frequency])
The first basic parameter "" (Wizard function) is displayed.
Press either the or key to select "".
Pressing the ENT key reads the maximum frequency.
Press the key to change the maximum frequency to 60Hz.
Press the ENT key to save the maximum frequency.  and the
frequency are displayed alternately.
→Switches to the
MODE
display in the
status monitor
mode.
D-4
E6581381
* Parameters were
factory-set by default
before shipment.
* Select the parameter to
be changed from "Table
of parameters".
* If there is something
that you do not
understand during the
operation, press the
MODE key to return to
the  indication.
⇒ See section 11.2 for
basic parameters.
Operation
→Displays names
of other
parameters.