Frequency Priority Selection - Toshiba TOSVERT VF-FS1 Instruction Manual

Setting of switching terminals
The terminal for switching to motor 2 needs to be set, since this function is not assigned under the default
setting. Assign this function to an idle terminal.
The parameters to be switched depend on the particular identification number of the input terminal selection
function.
6
Note: The parameters  ,  ,  ,  and  cannot be switched during operation. You need
6.5

Frequency priority selection

6.5.1
 : Frequency setting mode selection 1
 : Frequency priority selection
 : Speed setting mode selection 2
• Function
Input terminal function number
5 39 40
AD2 VF2 MOT2
OFF OFF OFF
ON OFF OFF
OFF OFF OFF
OFF ON OFF
- - ON
to stop operation when switching them.
Using a frequency command according to the particular
situation
These parameters are used to switch between two types of frequency command signals.
• Setting by parameters
• Switching by frequency
• Switching via terminal board input
61 Parameters used and applicable parameters
OCS2
Default setting: , , , , , ,
OFF
, , 
 → ,  → ,
OFF
 → 
ON
 → 
 = ,  → ,  → , 
OFF
 → ,  → 
 = ,  → ,  → ,
 → ,  → ,
-
 → ,  → ,
 → ,  → 
F-16
E6581381