Toshiba TOSVERT VF-FS1 Instruction Manual page 166

6.20.2 Changing the unit to A / V
 :Current / voltage unit
• Function
Example of setting
During the operation of the VFFS1-2037PM (rated current: 17.5A) at the rated load (100% load), units are
displayed as follows:
1) Display in percentage terms
 
 
6

*
These parameters are used to change the unit of monitor display.
% ⇔ A (ampere) / V (volt)
%
Output current:
100%
%
DC voltage:
100%
Title Function
Current/voltage
display mode
The  converts the following parameter settings:
• A display Current monitor display
Motor electronic-thermal protection level 1 and 2
DC braking current
Stall prevention level 1 and 2
Small current detection current
Step-out detection current level
(for PM motors)
• V display Voltage monitor display
Note: Base frequency voltage 1 and 2 I(, )s always displayed in the unit of V.
2) Display in amperes/volts
Output current:
.
17.5A
DC voltage:
200V (value

converted into
AC)
Adjustment range
0: %
1: A (ampere)/V (volt)
, 

, 


F-74
E6581381
Default setting
0