Toshiba TOSVERT VF-FS1 Instruction Manual page 94

An example of the connection of the relay output terminals
• Output terminal setting
6
6.1.2
 : Speed reach detection band
• Function
[Parameter setting]

[Parameter setting]
 
Note: Select the  parameter to specify FLA-FLC-FLB terminal output.
Output of the low-speed signal (ON signal) between the RY and RC terminals is the factory default
setting of the output terminal selection parameter. This setting must be changed to invert the polarity of
the signal.
[Parameter setting]
Title Function
Output terminal
selection 1A (RY-

RC)
Output of designated frequency reach signal
When the output frequency becomes equal to the setting by designated frequency ±, an ON or
OFF signal is generated.
Title Function
Speed reach detection band
Title Function
Output terminal
selection 1A
(RY-RC)
Adjustment range
0-255
(⇒ See page K-17)
0.0 ∼  (Hz)
Adjustment range
0-255 6: RCH (designated frequency - ON signal), or
7: RCHN (designated frequency - OFF signal)
(⇒ See page K-17)
F-2
Setting value
4 LOW (Low speed signal - ON signal) or
5 LOWF (Low speed signal - OFF signal)
Adjustment range Default setting
Setting value
E6581381
2.5