8. Monitoring the operation status
Refer to section 4.1 about flow of monitor.
8.1
Status monitor mode
8.1.1
Status monitor under normal conditions
In this mode, you can monitor the operation status of the inverter.
To display the operation status during normal operation:
Press the
Setting procedure (eg. operation at 60Hz)
Item displayed
Parameter setting
mode
Direction of
rotation
Operation
Note 1
frequency
command
Note 2
Load current
Note 3
Input voltage
Output voltage
Torque
Torque current
Inverter load factor
Input power
Output power
Operation
frequency
(Continued overleaf)
key twice.
MODE
Key
LED
operated
display
MODE
MODE
k
Communic
ation No.
The operation frequency is displayed (Operation at
60Hz). (When standard monitor display selection
is set at 0 [operation frequency])
The first basic parameter "" (Wizard function)
is displayed.
The direction of rotation is displayed.
FE01
(: forward run, : reverse run)
The operation frequency command value (Hz/free
FE02
unit) is displayed.
The inverter output current (load current) (%/A) is
FE03
displayed.
The inverter input voltage (DC detection) (%/V) is
FE04
displayed.
FE05
The inverter output voltage (%/V) is displayed.
FE18
The torque (%) is displayed.
FE20
The torque current (%/A) is displayed.
FE27
The inverter load factor (%) is displayed.
FE29
The inverter input power (kW) is displayed.
FE30
The inverter output power (kW) is displayed.
The operation frequency (Hz/free unit) is
FD00
displayed.
H-1
E6581381
Description
8