Figure 195 Snmp; Table 126 Snmp - ZyXEL Communications ZyWall 35 User Manual

ZyWALL 35 User's Guide

Figure 195 SNMP

The following table describes the labels in this screen.

Table 126 SNMP

LABEL
SNMP
Configuration
Get Community
Set Community
Trap
Community
Destination
SNMP
Service Port
Service Access
Secure Client IP
Address
Apply
Reset
370
DESCRIPTION
Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station. The default is public and allows all requests.
Enter the Set community, which is the password for incoming Set requests from the
management station. The default is public and allows all requests.
Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyWALL using this
service.
A secure client is a "trusted" computer that is allowed to communicate with the
ZyWALL using this service.
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyWALL using this service.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter 21 Remote Management