ZyXEL Communications ZyWall 35 User Manual page 321

Table 107 Edit IP Policy Route (continued)
LABEL
Packet Length
Length
Comparison
Source
Interface
Starting IP
Address
Ending IP
Address
Starting Port
Ending Port
Destination
Starting IP
Address
Ending IP
Address
Starting Port
Ending Port
Action Applies to
Routing Action
Gateway
Converted Type
of Service
Converted
Precedence
Log
Apply
Cancel
Chapter 18 Policy Route
DESCRIPTION
Type a length of packet (in bytes). The operators in the Len Compare field apply to
incoming packets of this length.
Choose from Equal, Not Equal, Less, Greater, Less or Equal or Greater or
Equal.
Use the check box to select LAN, DMZ, WAN_1 and/or WAN_2.
Enter the source starting IP address.
Enter the source ending IP address.
Enter the source starting port number. This field is applicable only when you select
TCP or UDP in the IP Protocol field.
Enter the source ending port number. This field is applicable only when you select
TCP or UDP in the IP Protocol field.
Enter the destination starting IP address.
Enter the destination ending IP address.
Enter the destination starting port number. This field is applicable only when you
select TCP or UDP in the IP Protocol field.
Enter the destination ending port number. This field is applicable only when you
select TCP or UDP in the IP Protocol field.
Specifies whether action should be taken on criteria Matched or Not Matched.
Select User-Defined and enter the IP address of the gateway if you want to specify
the IP address of the gateway. The gateway is an immediate neighbor of your
ZyWALL that will forward the packet to the destination. The gateway must be a
router on the same segment as your ZyWALL's LAN or WAN port.
Select WAN Interface to have the ZyWALL send traffic that matches the policy
route through a specific WAN port. Select the WAN port from the drop-down list
box.
Select the Use another interface when the specified WAN interface is not
available. check box to have the ZyWALL send traffic that matches the policy route
through the other WAN interface if it cannot send the traffic through the WAN
interface you selected. This option is only available when you select WAN
Interface.
Set the new TOS value of the outgoing packet. Prioritize incoming network traffic by
choosing Don't Change, Normal, Min Delay, Max Thruput, Max Reliable or Min
Cost.
Set the new outgoing packet precedence value. Values are 0 to 7 or Don't
Change.
Select Yes from the drop-down list box to make an entry in the system log when a
policy is executed.
Click Apply to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
ZyWALL 35 User's Guide
319