Pre-Defined Ntp Time Servers List; Figure 207 Password Setup; Table 140 Password Setup; Table 141 Default Time Servers - ZyXEL Communications ZyWall 35 User Manual

Figure 207 Password Setup

The following table describes the labels in this screen.

Table 140 Password Setup

LABEL
Old Password
New Password
Retype to Confirm
Apply
Reset

24.4 Pre-defined NTP Time Servers List

The ZyWALL uses the following pre-defined list of NTP time servers if you do not specify a
time server or it cannot synchronize with the time server you specified.
When the ZyWALL uses the pre-defined list of NTP time servers, it randomly selects one
server and tries to synchronize with it. If the synchronization fails, then the ZyWALL goes
through the rest of the list in order from the first one tried until either it is successful or all the
pre-defined NTP time servers have been tried.

Table 141 Default Time Servers

ntp1.cs.wisc.edu
ntp1.gbg.netnod.se
ntp2.cs.wisc.edu
tock.usno.navy.mil
Chapter 24 Maintenance
DESCRIPTION
Type the default password or the existing password you use to access the system
in this field.
Type your new system password (up to 30 characters). Note that as you type a
password, the screen displays a (*) for each character you type.
Type the new password again for confirmation.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Note: The ZyWALL can use this pre-defined list of time servers
regardless of the Time Protocol you select.
ZyWALL 35 User's Guide
397