Figure 212 Device Mode (Router Mode); Table 143 Device Mode (Router Mode) - ZyXEL Communications ZyWall 35 User Manual

ZyWALL 35 User's Guide

Figure 212 Device Mode (Router Mode)

The following table describes the labels in this screen.

Table 143 Device Mode (Router Mode)

LABEL
Current Device
Mode
Device Mode
Device Mode Setup
Router
IP Address
Bridge
IP Address
Subnet Mask
Gateway IP
Address
Apply
Reset
When the ZyWALL is in bridge mode, the screen appears as shown next
402
DESCRIPTION
This displays whether the ZyWALL is functioning as a router or a bridge.
When the ZyWALL is in router mode, there is no need to select or clear this radio
button.
Click LAN, WAN or DMZ to go to the LAN, WAN or DMZ screen where you can
view and/or change the corresponding settings.
Select this radio button and configure the following fields, then click Apply to set
the ZyWALL to bridge mode.
Enter the IP address of your ZyWALL in dotted decimal notation.
Enter the IP subnet mask of the ZyWALL.
Enter the gateway IP address.
Click Apply to save your changes back to the ZyWALL. After you click Apply,
please wait for one minute and use the IP address you configured in the IP
Address field to access the ZyWALL again.
Click Reset to begin configuring this screen afresh.
Chapter 24 Maintenance