Figure 266 Menu 11.1.2: Remote Node Network Layer Options For Ethernet Encapsulation; Table 176 Remote Node Network Layer Options Menu Fields - ZyXEL Communications ZyWall 35 User Manual

Figure 266 Menu 11.1.2: Remote Node Network Layer Options for Ethernet Encapsulation

This menu displays the My WAN Addr field for PPPoE and PPTP encapsulations and
Gateway IP Addr field for Ethernet encapsulation. The following table describes the fields
in this menu.

Table 176 Remote Node Network Layer Options Menu Fields

FIELD
IP Address
Assignment
(Rem) IP
Address
(Rem) IP
Subnet Mask
Gateway IP
Addr
My WAN Addr This field is applicable to PPPoE and PPTP encapsulations only. Some
Chapter 32 Remote Node Setup
Menu 11.1.2 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
Rem IP Addr= N/A
Rem Subnet Mask= N/A
My WAN Addr= N/A
Network Address Translation= SUA Only
NAT Lookup Set= 255
Metric= 1
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTION
If your ISP did not assign you an explicit IP address, press [SPACE BAR] and then
[ENTER] to select Dynamic; otherwise select Static and enter the IP address &
subnet mask in the following fields.
If you have a static IP Assignment, enter the IP address assigned to you by your ISP.
If you have a static IP Assignment, enter the subnet mask assigned to you.
This field is applicable to Ethernet encapsulation only. Enter the gateway IP address
assigned to you if you are using a static IP address.
implementations, especially the UNIX derivatives, require the WAN link to have a
separate IP network number from the LAN and each end must have a unique address
within the WAN network number. If this is the case, enter the IP address assigned to
the WAN port of your ZyWALL.
Note that this is the address assigned to your local ZyWALL, not the remote router.
ZyWALL 35 User's Guide
463