Ike Phases; Figure 19 Two Phases To Set Up The Ipsec Sa - ZyXEL Communications ZyWall 35 User Manual

ZyWALL 35 User's Guide
Table 17 VPN Wizard : Network Setting
LABEL
Starting IP
Address
Ending IP
Address/
Subnet Mask
Back
Next

3.4.4 IKE Phases

There are two phases to every IKE (Internet Key Exchange) negotiation – phase 1
(Authentication) and phase 2 (Key Exchange). A phase 1 exchange establishes an IKE SA and
the second one uses that SA to negotiate SAs for IPSec.

Figure 19 Two Phases to Set Up the IPSec SA

In phase 1 you must:
• Choose a negotiation mode.
• Authenticate the connection by entering a pre-shared key.
• Choose an encryption algorithm.
• Choose an authentication algorithm.
• Choose a Diffie-Hellman public-key cryptography key group (DH1 or DH2).
86
DESCRIPTION
When the Remote Network field is configured to Single, enter a (static) IP address
on the network behind the remote IPSec router. When the Remote Network field is
configured to Range IP, enter the beginning (static) IP address, in a range of
computers on the network behind the remote IPSec router. When the Remote
Network field is configured to Subnet, enter a (static) IP address on the network
behind the remote IPSec router
When the Remote Network field is configured to Single, this field is N/A. When the
Remote Network field is configured to Range IP, enter the end (static) IP address, in
a range of computers on the network behind the remote IPSec router. When the
Remote Network field is configured to Subnet, enter a subnet mask on the network
behind the remote IPSec router.
Click Back to return to the previous screen.
Click Next to continue.
Chapter 3 Wizard Setup