Figure 247 Menu 3.2.1: Ip Alias Setup; Table 164 Menu 3.2.1: Ip Alias Setup - ZyXEL Communications ZyWall 35 User Manual

Figure 247 Menu 3.2.1: IP Alias Setup

Use the instructions in the following table to configure IP alias parameters.

Table 164 Menu 3.2.1: IP Alias Setup

FIELD
IP Alias 1, 2
IP Address
IP Subnet Mask
RIP Direction
Version
Incoming
Protocol Filters
Outgoing
Protocol Filters
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm...] to
save your configuration, or press [ESC] at any time to cancel.
Chapter 28 LAN Setup
Menu 3.2.1 - IP Alias Setup
IP Alias 1= Yes
IP Address= 192.168.2.1
IP Subnet Mask= 255.255.255.0
RIP Direction= None
Version= RIP-1
Incoming protocol filters=
Outgoing protocol filters=
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTION
Choose Yes to configure the LAN network for the ZyWALL.
Enter the IP address of your ZyWALL in dotted decimal notation.
Your ZyWALL will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the ZyWALL.
Press [SPACE BAR] and then [ENTER] to select the RIP direction. Options are
Both, In Only, Out Only or None.
Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are
RIP-1, RIP-2B or RIP-2M.
Enter the filter set(s) you wish to apply to the incoming traffic between this node and
the ZyWALL.
Enter the filter set(s) you wish to apply to the outgoing traffic between this node and
the ZyWALL.
ZyWALL 35 User's Guide
441