Table 158 Menu 11.3: Remote Node Profile (Backup Isp) - ZyXEL Communications ZyWall 35 User Manual

ZyWALL 35 User's Guide
The following table describes the fields in this menu.

Table 158 Menu 11.3: Remote Node Profile (Backup ISP)

FIELD
Rem Node
Name
Active
Outgoing
My Login
My Password
Retype to
Confirm
Authen
Pri Phone #
Sec Phone #
Edit PPP
Options
Rem IP Addr
Edit IP
Edit Script
Options
Telco Option
Allocated
Budget
Period(hr) Enter the time period (in hours) for how often the budget should be reset. For
Schedules
Nailed-Up
Connection
Session
Options
430
DESCRIPTION
Enter a descriptive name for the remote node. This field can be up to eight characters.
Press [SPACE BAR] and then [ENTER] to select Yes to enable the remote node or
No to disable the remote node.
Enter the login name assigned by your ISP for this remote node.
Enter the password assigned by your ISP for this remote node.
Enter your password again to make sure that you have entered is correctly.
This field sets the authentication protocol used for outgoing calls.
Options for this field are:
CHAP/PAP - Your ZyWALL will accept either CHAP or PAP when requested by this
remote node.
CHAP - accept CHAP only.
PAP - accept PAP only.
Enter the first (primary) phone number from the ISP for this remote node. If the
Primary Phone number is busy or does not answer, your ZyWALL dials the
Secondary Phone number if available. Some areas require dialing the pound sign #
before the phone number for local calls. Include a # symbol at the beginning of the
phone numbers as required.
Move the cursor to this field and use the space bar to select [Yes] and press [Enter] to
edit the PPP options for this remote node. This brings you to Menu 11.3.1 - Remote
Node PPP Options (see the Editing PPP Options
Leave the field set to 0.0.0.0 (default) if the remote gateway has a dynamic IP
address. Enter the remote gateway's IP address here if it is static.
This field leads to a "hidden" menu. Press [SPACE BAR] to select Yes and press
[ENTER] to go to Menu 11.3.2 - Remote Node Network Layer Options. See
Editing TCP/IP Options section
Press [SPACE BAR] to select Yes and press [ENTER] to edit the AT script for the dial
backup remote node (Menu 11.3.3 - Remote Node Script). See
Script section for more information.
Enter the maximum number of minutes that this remote node may be called within the
time period configured in the Period field. The default for this field is 0 meaning there
is no budget control and no time limit for accessing this remote node.
example, to allow calls to this remote node for a maximum of 10 minutes every hour,
set the Allocated Budget to 10 (minutes) and the Period to 1 (hour).
You can apply up to four schedule sets here. For more details please refer to
Chapter 43 Call Scheduling.
Press [SPACE BAR] to select Yes to set this connection to always be on, regardless
of whether or not there is any traffic. Select No to have this connection act as a dial-
up connection.
section).
for more information.
Chapter 27 WAN and Dial Backup Setup
the
the Editing Login