Configuring Summary; Figure 162 Bandwidth Manager: Summary; Table 109 Bandwidth Manager: Summary - ZyXEL Communications ZyWall 35 User Manual

Internet security appliance

Hide thumbs Also See for ZyWall 35:

Table of Contents

ZyWALL 35 User's Guide

3 The ZyWALL assigns any remaining unused or unbudgeted bandwidth on the interface to

any bandwidth class that requires it. The ZyWALL gives priority to bandwidth classes of

higher priority and treats bandwidth classes of the same level equally.

4 The ZyWALL assigns any remaining unbudgeted bandwidth to traffic that does not

match any of the bandwidth classes.

19.8 Configuring Summary

Click BW MGMT to open the Summary screen.

Enable bandwidth management on an interface and set the maximum allowed bandwidth for

that interface.

The following table describes the labels in this screen.

Speed (kbps)

These read-only labels represent the physical interfaces. Select an interface's check

box to enable bandwidth management on that interface. Bandwidth management

applies to all traffic flowing out of the router through the interface, regardless of the

traffic's source.

Traffic redirect or IP alias may cause LAN-to-LAN or DMZ-to-DMZ traffic to pass

through the ZyWALL and be managed by bandwidth management.

Select an interface's check box to enable bandwidth management on that interface.

Enter the amount of bandwidth for this interface that you want to allocate using

bandwidth management.

This appears as the bandwidth budget of the interface's root class

Configuring Class Setup

section). The recommendation is to set this speed to match

what the device connected to the port can handle. For example, set the WAN

interface speed to 1000 kbps if the broadband device connected to the WAN port

has an upstream speed of 1000 kbps.

Chapter 19 Bandwidth Management