Figure 246 Menu 3.2: Tcp/Ip And Dhcp Ethernet Setup; Table 162 Menu 3.2: Dhcp Ethernet Setup Fields; Table 163 Menu 3.2: Lan Tcp/Ip Setup Fields - ZyXEL Communications ZyWall 35 User Manual

Figure 246 Menu 3.2: TCP/IP and DHCP Ethernet Setup

DHCP= Server
Client IP Pool:
Starting Address= 192.168.1.33
Size of Client IP Pool= 128
DHCP Server Address= N/A
Follow the instructions in the next table on how to configure the DHCP fields.

Table 162 Menu 3.2: DHCP Ethernet Setup Fields

FIELD
DHCP
Client IP Pool:
Starting Address
Size of Client IP
Pool
DHCP Server
Address
Use the instructions in the following table to configure TCP/IP parameters for the LAN port.

Table 163 Menu 3.2: LAN TCP/IP Setup Fields

FIELD
TCP/IP Setup:
IP Address
Chapter 28 LAN Setup
Menu 3.2 - TCP/IP and DHCP Ethernet Setup
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
This field enables/disables the DHCP server.
If set to Server, your ZyWALL will act as a DHCP server.
If set to None, the DHCP server will be disabled.
If set to Relay, the ZyWALL acts as a surrogate DHCP server and relays requests
and responses between the remote server and the clients.
When set to Server, the following items need to be set:
This field specifies the first of the contiguous addresses in the IP address pool.
This field specifies the size, or count of the IP address pool.
If Relay is selected in the DHCP field above, then type the IP address of the actual,
remote DHCP server here.
Note: LAN and DMZ IP addresses must be on separate
subnets.
DESCRIPTION
Enter the IP address of your ZyWALL in dotted decimal notation
ZyWALL 35 User's Guide
TCP/IP Setup:
IP Address= 192.168.1.1
IP Subnet Mask= 255.255.255.0
RIP Direction= Both
Version= RIP-1
Multicast= None
Edit IP Alias= No
439