Ftp Session Example Of Firmware File Upload; Tftp File Upload; Figure 337 Ftp Session Example Of Firmware File Upload - ZyXEL Communications ZyWall 35 User Manual

Internet security appliance
Hide thumbs Also See for ZyWall 35:
Table of Contents

Advertisement

ZyWALL 35 User's Guide
2 Enter "open", followed by a space and the IP address of your ZyWALL.
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter "bin" to set transfer mode to binary.
6 Use "put" to transfer files from the computer to the ZyWALL, for example, "put
firmware.bin ras" transfers the firmware on your computer (firmware.bin) to the
ZyWALL and renames it "ras". Similarly, "put config.rom rom-0" transfers the
configuration file on your computer (config.rom) to the ZyWALL and renames it "rom-
0". Likewise "get rom-0 config.rom" transfers the configuration file on the ZyWALL to
your computer and renames it "config.rom." See earlier in this chapter for more
information on filename conventions.
7 Enter "quit" to exit the ftp prompt.

39.5.4 FTP Session Example of Firmware File Upload

Figure 337 FTP Session Example of Firmware File Upload

More commands (found in GUI-based FTP clients) are listed earlier in this chapter.
Refer to
the File Maintenance Over WAN section
TFTP and FTP over WAN.

39.5.5 TFTP File Upload

The ZyWALL also supports the uploading of firmware files using TFTP (Trivial File Transfer
Protocol) over LAN. Although TFTP should work over WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware
and the configuration file, follow the procedure shown next.
1 Use telnet from your computer to connect to the ZyWALL and log in. Because TFTP
does not have any security checks, the ZyWALL records the IP address of the telnet
client and accepts TFTP requests only from this address.
530
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds
297.89Kbytes/sec.
ftp> quit
Chapter 39 Firmware and Configuration File Maintenance
to read about configurations that disallow

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zywall 70

Table of Contents