Figure 241 Menu 11.3.3: Remote Node Script
The following table describes the fields in this menu.
Table 161 Menu 11.3.3: Remote Node Script
FIELD
Active
Set 1-6:
Expect
Set 1-6:
Send
27.10 Remote Node Filter
Move the cursor to the field Edit Filter Sets in menu 11.3, and then press [SPACE BAR] to
set the value to Yes. Press [ENTER] to open Menu 11.3.4 - Remote Node Filter
Use menu 11.3.4 to specify the filter set(s) to apply to the incoming and outgoing traffic
between this remote node and the ZyWALL to prevent certain packets from triggering calls.
You can specify up to four filter sets separated by commas, for example, 1, 5, 9, 12, in each
filter field. Note that spaces are accepted in this field. Please refer to
Configuration
Chapter 27 WAN and Dial Backup Setup
Menu 11.3.3 - Remote Node Script
Active= No
Set 1:
Expect=
Send=
Set 2:
Expect=
Send=
Set 3:
Expect=
Send=
Set 4:
Expect=
Send=
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTION
Press [SPACE BAR] and then [ENTER] to select either Yes to enable the AT strings or
No to disable them.
Enter an Expect string to match. After matching the Expect string, the ZyWALL returns
the string in the Send field.
Enter a string to send out after the Expect string is matched.
for more information on defining the filters.
ZyWALL 35 User's Guide
Set 5:
Expect=
Send=
Set 6:
Expect=
Send=
.
Chapter 36 Filter
435