Configuring Reports - ZyXEL Communications ZyWall 35 User Manual

ZyWALL 35 User's Guide
Table 133 Log Settings (continued)
LABEL
Active
Log Consolidation
Period
Apply
Reset

23.4 Configuring Reports

The Reports page displays which computers on the LAN send and receive the most traffic,
what kinds of traffic are used the most and which web sites are visited the most often. Use the
Reports screen to have the ZyWALL record and display the following network usage details:
• Web sites visited the most often
• Number of times the most visited web sites were visited
• The most-used protocols or service ports
• The amount of traffic for the most used protocols or service ports
• The LAN IP addresses to and/or from which the most traffic has been sent
• How much traffic has been sent to and from the LAN IP addresses to and/or from which
the most traffic has been sent
The ZyWALL records web site hits by counting the HTTP GET packets. Many web sites
include HTTP GET references to other web sites and the ZyWALL may count these as hits,
thus the web hit count is not (yet) 100% accurate.
To change your ZyWALL's log reports, click LOGS, then the Reports tab. The screen
appears as shown.
390
DESCRIPTION
Some logs (such as the Attacks logs) may be so numerous that it becomes
easy to ignore other important log messages. Select this check box to merge
logs with identical messages into one log.
You can use the sys log consolidate msglist command to see what
log messages will be consolidated.
Specify the time interval during which the ZyWALL merges logs with identical
messages into one log.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Note: The web site hit count may not be 100% accurate
because sometimes when an individual web page loads, it may
contain references to other web sites that also get counted as
hits.
Chapter 23 Logs Screens