Chapter 3
General Settings
3.4
Firewall Settings
Initial setup 1 is complete and the screen returns to the [Login] screen.
(2)
Close the Web browser.
9
Restart the Web browser and log in to ETERNUS Web GUI with the changed IP address.
3.4
Firewall Settings
Set the firewall for each service. The settings are required respectively for the MNT port and the RMT port.
If both HTTP connection and HTTPS connection are disabled, the device is inaccessible via ETERNUS Web
•
GUI.
If both Telnet connection and SSH connection are disabled, the device is inaccessible via ETERNUS CLI.
•
•
If the network environment for the MNT port is not set up, some functions will be unusable. Make sure
to set up the network environment.
1
Click the [System] tab on the navigation of the ETERNUS Web GUI screen.
2
In [Category], click [Network].
The [Network] screen appears.
3
Select the port to be set. In [Action], click [Setup Firewall].
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
47
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0