Table of Contents
Advertisement
Summary of OUTPUT Command Parameters
Parameter
FORMAT=
pde-id
88
Definition(s)
Note: Continuous feed printer cannot physically sup-
port multiple stocks within a report. It does, however,
logically support the changing of stocks. When a
FEED=DJDE is applied which specifies a stock (us-
ing a stock-reference, a stock-name, or one of the
supported keywords) which is different than the stock
currently in effect the next logical page will be printed
as the first logical page on the front of the next page.
In the LCDS-Module the relation of stock-name and
the corresponding input bin of the printer is defined in
the stockset-configuration-table. With the parameter
PrinterTyp set to CutSheet the stock-names are to be
defined as paper names (Media Name) on the printer
panel. (see "Configuring LCDS-Module Parameters"
and "PrinterTyp" in Administrator's Guide). Please re-
fer to the User Guide for further information.
If FEED switches to AUX-tray, an (additional) form
may be printed on the sheet (see "Configuring LCDS-
Module Parameters" and "AUX_FRONT/
AUX_BACK" in Administrator's Guide)
pde-id
References a PDE that must have been defined pre-
viously in a JDL or may make reference to a PDE file
separately cataloged in the PDE directory on disk.
Standard pde-ids are defined below "PDE command"
in this chapter, such as FMT1 and FMT2. These
standard pde-ids are part of the software and may be
used unless a specialized PDE must be defined. An
active PDE may subsequently be replaced entirely or
modified in part through DJDEs (refer to the chapter
"Specifying dynamic job descriptor entries (DJDEs)".
Details on the PDE parameter are discussed in the
"Page descriptors" section of this chapter. Creating
and compiling PDE files with the XDL processor is
discussed in the "Compiling the JSL" section in the
chapter "Creating a job source library (JSL)." The de-
fault is FMT1.
Print Processing
Offline
Online
DJDE
Y
Y
A29247-X4-X-8-7672
Y
Advertisement
Table of Contents
