Oce XDL Reference Manual page 186

Page- and Record-oriented DJDEs
DJDE
INKINDEX=
offset |
(offset[, init-val]
[, bit-opt])
INKINDEX=
NONE
ITEXT=
NONE
ITEXT=
(sc[,passnum])
JDE=
jde-id
JDL=
jdl-id
178
Definition(s)
Allows the user to specify a certain location in the input record where an index to
the ink to be used is stored. It takes effect on the next logical page boundary.
offset
Indicates the byte offset in the data record where the ink index number is to be
found.
init-val
Can be one of the following: ONE or ZERO. ONE specifies that an index value of
1 is associated with the first ink in the ink list. When the bit-opt parameter is used,
the init-val ONE parameter must also be used. ZERO specifies that an index val-
ue of 0 is associated with the first ink in the ink list, an index value of 1 is associ-
ated with the second ink in the ink list, and so forth. The default is ONE.
bit-opt
A numeral having a value in the range of 1 through 7, which specifies the number
of low-order bits within the ink index byte, which, in turn, specifies an index value
into the ink list of the current PDE. The default value is 4.
If init-val is ONE or is not specified, the value of the ink index byte in the data
record is a number in the range 1 to n, where n is the number of inks specified in
the PDE parameter (1 to 127). If ZERO is specified, the ink index is a number in
the range 0 to n, where n is the number of inks specified in the PDE parameter
minus one (0 to 127). The ink index value must be present in every record. If the
INKINDEX in the data record is greater than the number of inks specified, the first
ink in the list is used.
NONE
Specifies that there is no ink index.
The default is NONE.
NONE
Specifies that no text message is output to the operator during input processing.
The default is NONE.
sc
Specifies a text message of up to 80 characters.
passnum
Specifies the pass (copy ply) to which the message text applies. The message is
output to the operator just before processing of the indicated pass (copy ply) is
begun. If no pass number is specified, the indicated message is output at the be-
ginning of the first pass.
jde-id
Specifies the JDE to be used within the selected JDL at the next page boundary.
jdl-id
The jdl-id specifies the name of the JDL to be invoked at the next page boundary.
Dynamic Job Descriptor Entries (DJDEs)
A29247-X4-X-8-7672