Oce XDL Reference Manual page 198

Page- and Record-oriented DJDEs
DJDE
IMAGE=
(img-name,
vpos units,
hpos units
[, H] [, T] [, D]
[, n[/d]]
[, (INKS,
inkref
[, inkref]
[, ...])])
190
Definition(s)
This DJDE sentinel is used to position a graphic image on the page.
img-name
Specifies the name of a graphic image file.
vpos
Specifies the vertical position (top left corner of page) of the top edge of the
graphic, as an offset relative to 0,0 on the current physical page (the position that
would be specified by a PDE BEGIN of 0,0). This parameter is specified as a dec-
imal number with up to three digits to the right of the decimal point.
hpos
Specifies the horizontal position of the left edge of the graphic as an offset, rela-
tive to 0,0 on the current physical page. The units of the specification is the same
as for vpos. This parameter is specified as a decimal number with up to three dig-
its to the right of the decimal point.
units
DOTS (300 dots per inch), XDOTS (600 dots per inch), centimeters (CM), user-
defined units (UN) or inches (IN). If no units are specified, inches are assumed.
H
Specifies that this graphic is to be held and imaged without further references, at
the same position and with the same scale factor on all subsequent pages until
changed by a DJDE CANCEL= or ALTER=.
T
Specifies that the referenced graphic is page interleaved and follows the current
page data in the input stream.
n/d
Specifies the reference scale factor. Each parameter, n and d, must be an inte-
ger in the range of one to eight, thereby allowing a reference scale factor in the
range of 1/8 to eight.
Scaling can result in performance problems. Scaling is done exclusively page
by page.
inkref
Specifies which inks in the ILIST parameter of the IDR command override the
corresponding inks specified in the inklist of the image.
If one inkref in the list is omitted, commas must be used to maintain the relative
positioning of the remaining ink references.
If more inkrefs are specified than contained in the inklist of the image, the extra
inkrefs are ignored.
Existing images are printed in black unless inkrefs are specified in the INKS pa-
rameter.
Inkrefs may be entered as ink names or as numeric ink indices using an inklist
specified by an DJDE-ILIST command or the JSL-IDR ILIST parameter which is
referenced by an JSL-OUTPUT IDR parameter or the DJDE-IDR command.
Only references to primary colours are allowed.
Dynamic Job Descriptor Entries (DJDEs)
A29247-X4-X-8-7672