Table of Contents
Advertisement
Print Processing
Parameter
BEGIN=
(vpos,hpos)
FONTS=
(f
[,f
][,...]) |
1
2
((f
,s
)
1
1
[,(f
,s
)][,...])|
2
2
((f
,s
,[LPI |
1
1
DOTS])
[,(f
,s
,[LPI |
2
2
DOTS])][,...])
PMODE=
LANDSCAPE
PMODE=
PORTRAIT
A29247-X4-X-8-7672
Definition(s)
This option has the following components:
vpos
Specifies a decimal number with up to three digits to
the right of the decimal point, such as 0.563 IN and
2.35 CM, are all legal specifications).
The default is .18 IN.
hpos
Specifies the horizontal position of the first character
of the first print line on the logical page (in IN or CM
as for vpos). All specifications are rounded to the
nearest dot (1/300 of an inch) for positioning of the
logical page.
The default is .66.
This option has the following components:
f
Specifies a one-to-six alphanumeric character identi-
fier (consisting of at least one letter) corresponding to
a font cataloged on the system disk (up to 128 fonts
can be used with the font indexing capability).
s
Specifies an optional override line-spacing value de-
fined by either the print lines per inch (LPI) or the dots
per print line (DOTS) to be associated with the font.
Maximum value for si is 30 LPI; minimum value is 10
dots. If unit (LPI or DOTS) is not specified, LPI is as-
sumed by default.
LANDSCAPE
Indicates that printing is to be parallel to the long
edge of paper.
The default is LANDSCAPE.
PORTRAIT
Indicates that printing is to be parallel to the narrow
edge of paper.
Summary of PDE Command Parameters
Offline
Y
Y
Y
Online
DJDE
Y
Y
Y
Y
Y
Y
123
Advertisement
Table of Contents
