Table of Contents
Advertisement
Input Processing
Parameter
MINLAB=
value
PLABEL=
YES/NO
RMULT=
value
TCODE=
tcode-type
TCODE=
tcode-id
UNPACK=
NONE
UNPACK=
UNIVAC
Points to note
Note the following when using the VOLUME command:
A29247-X4-X-8-7672
Summary of VOLUME Command Parameters
Definition(s)
value
Specifies in bytes the maximum length of the
smallest physical block. The value can range
from 1 to 4095 bytes. The specified value must
be less than the MAXLAB value and must not ex-
ceed the BLOCK LENGTH.
The default is 80.
Specifies whether the tape labels are to be print-
ed. If YES is specified, all tape labels (except
those encountered during a volume change) are
printed on an output page and delivered to the
sample tray or output bin. Labels are truncated if
they exceed the line width limits of the page. If
NO is specified, no tape label printing results.
The default is NO.
value
An integer from 1 to 15.
The default is 1.
tcode-type
Specifies one of the following standard character
sets for which type assignments are defined by
default:
ASCII
EBCDIC
By coding any one of the keywords, you are fur-
nished with a set of character-to-type assign-
ments.
tcode-id
Specifies an identified label of a TCODE param-
eter that defines a set of type assignments
NONE
Does not perform the unpacking operation.
The default is NONE.
UNIVAC
Specifies an unpacking routine used for UNIVAC
tapes, although you can specify any of these
routines independent of the HOST type.
Offline
Online
DJDE
Y
N
N
Y
N
-
Y
N
N
Y
Y
N
Y
N
N
51
Advertisement
Table of Contents
