Oce XDL Reference Manual page 187

Dynamic Job Descriptor Entries (DJDEs)
DJDE
MARGIN=
{value |
(value,value-
type)}
MODIFY=
(cme-id,[init]
[,copies])
MODIFY=
NONE
A29247-X4-X-8-7672
Definition(s)
This option has the following components:
value
The form nnn.mm (a positive decimal number with up to 2 digits to the right of the
decimal point) which is the distance from the left margin.
value-type
Indicates whether a value is specified in inches (IN), centimeters (CM), or char-
acter positions (POS). A value must be specified as an integer (nnn), if a value-
type is character positions. The default is (1,POS).
This option has the following components:
cme-id
The command identifier of a CME. The CME may be coded within a JSL or coded
and cataloged separately for use by several JSLs. Any CME invoked by a DJDE
must be cataloged separately (refer to the "Cataloged CMEs" section in this
chapter for further information). If the CME is within the JSL, it must precede a
reference to its identifier by the MODIFY parameter. Details on CME usage and
syntax are discussed in the "CME" section of the "Print format commands" chap-
ter.
init
Specifies the initial ply (pass) to which the associated CME is to be applied.
copies
Specifies the number of plies (passes) on which to apply the CME. If copies is
not specified, then the CME applies to all copies beginning with the copy number
specified by init.
NONE
Specifies that data are processed without modification.
The default is NONE.
Page- and Record-oriented DJDEs
179