Oce XDL Reference Manual page 199

Lcds-module xdl/djde
Table of Contents

Advertisement

Dynamic Job Descriptor Entries (DJDEs)
DJDE
LOGO=
(name, vpos
units,
hpos units
[, H]
[, (INKS, in-
kindex
[, inkindex]
[, ...])])
A29247-X4-X-8-7672
Definition(s)
name
Specifies the name of the logo. A logo specified through PDL will appear on all
pages of a record. A logo specified through DJDE will appear only on the current
page unless the hold option is specified.
vpos
Specifies the vertical position (top left corner of page) of the top edge of the logo,
as an offset relative to 0,0 on the current physical page (the position that would
be specified by a PDE BEGIN of 0,0). This parameter is specified as a decimal
number with up to three digits to the right of the decimal point.
hpos
Specifies the horizontal position of the left edge of the logo as an offset, relative
to 0,0 on the current physical page. The units of the specification is the same as
for vpos. This parameter is specified as a decimal number with up to three digits
to the right of the decimal point.
units
DOTS (300 dots per inch), XDOTS (600 dots per inch), centimeters (CM), user-
defined units (UN) or inches (IN). If no units are specified, inches are assumed.
H
Specifies that this logo is to be held and imaged without further references, at the
same position and with the same scale factor on all subsequent pages until
changed by a DJDE CANCEL= or ALTER=.
inkindex
Specifies which inks in the ILIST parameter of the IDR command override the
corresponding inks specified in the inklist of the logo. The logo must be in colour
format.
If one inkref in the list is omitted, commas must be used to maintain the relative
positioning of the remaining ink references.
If more inkrefs are specified than contained in the inklist of the logo, the extra
inkrefs are ignored.
If any of the inks to be substituted where specified in the logo definition with a
NOSUBSTITUTION parameter ink requests are processed according to what is
specified in the ISUBSTITUTE parameter of the ABNORMAL command.
Only references to primary colours are allowed.
Page- and Record-oriented DJDEs
191

Advertisement

Table of Contents
loading

This manual is also suitable for:

DjdePrismaproduction server v3.10

Table of Contents