Oce XDL Reference Manual page 82

Summary of LINE Command Parameters
Parameter
MARGIN=
{value |
(value,value-
type)}
OVERPRINT=
PRINT |
IGNORE |
MERGE |
PRINT2
74
Definition(s)
This option has the following components:
value
The form nnn.mm (a positive decimal number with up
to 2 digits to the right of the decimal point) which is
the distance from the left margin.
value-type
Indicates whether a value is specified in inches (IN),
centimeters (CM), or character positions (POS). A
value must be specified as an integer (nnn), if a val-
ue-type is character positions.
The default is (1,POS).
Specifies the manner in which overprint lines are
handled. (Overprint lines are print lines whose car-
riage control specifies printing with no line spacing
since the last printed line.).
PRINT
Specifies that all overprint lines are to be printed as
they would be on an impact printer; that is, the sec-
ond line is printed over the top of the first with no re-
gard to the previous data, including character
spacing, which may vary between the two lines of da-
ta.
IGNORE
All overprint lines are ignored.
MERGE
MERGE is the same as PRINT except when used
with FONTINDEX or CME processing.
PRINT2
Specifies that up to two consecutive lines will be
printed per line - one line and one overprint.
Other overprints for the line will be ignored.
The default is PRINT. PRINT2 & IGNORE are treat-
ed as PRINT.
Print Processing
Offline Online DJDE
Y Y
Y Y
A29247-X4-X-8-7672
Y
N