Oce XDL Reference Manual page 104

Summary of OUTPUT Command Parameters (Continuation)
Parameter
NTO1=NO
NTO1=n
NUMBER=
(pnum, lnum
,cnum
[, findex
[, inkref]])
NUMBER=
NO
96
Definition(s)
This parameter specifies the printing from first to last
page.
This is the default-value.
This parameter specifies the maximum number of
sheets a report may have in order for it to be printed
NTO1. If, however, the threshold count is reached
and an end-of-report condition is not met, the system
prints the entire report 1TON. The default value of
NTO1 is 50 physical sheets, but n may range from 1
to 100000. When the value is greater than 100, XDL
generates a warning message into the message win-
dow. PLABEL sheets are not counted for the thresh-
old.
pnum
Page number: specifies the starting number (an inte-
ger) for page numbering. The beginning page num-
ber may be non-positive. The number is incremented
at page transitions but not printed until it goes posi-
tive. The maximum page number that will be printed
is 9.999.999
lnum
Line number: specifies an integer line number on
which the page number is to be placed.
cnum
Column number: specifies an integer ending column
number for the page number sequence.
findex
Font index: the sequence number of the font to be
used to print the page number, selected from the list
of fonts specified in the FONTS parameter of the
PDE command. If not specified, the first font in the list
is used.
inkref
Specifies the ink to be used for printing the page
number. If not specified, the current default ink is
used.
Inkrefs may be entered as ink names or as numeric
ink indices using an inklist specified by an IDR ILIST
parameter which is referenced by an IDR parameter
in the same OUTPUT command.
Only a reference to a primary colour is allowed.
NO
Specifies that no page numbering is to be performed.
The default is NO.
Print Processing
Offline Online DJDE
Y Y
A29247-X4-X-8-7672
Y