Table of Contents
Advertisement
Using Logical Processing
Parameter
PRINT=
NONE
TEST=
test-exp
Points to note
Note the following when using the RSTACK command:
•
If the TEST expression on the RSTACK command consists solely of a change mode
CRITERIA command, DELIMITER=NO must be coded.
•
An RSTACK command containing a TEST expression specifying a constant mode CRI-
TERIA command and DELIMITER=NO can be used to detect a heading of a report as
a report boundary.
•
A record which is an RSTACK delimiter, that is, it satisfies the TEST expression, cannot
be deleted from or not selected for printing by the RSELECT or RDELETE logical pro-
cessing. If the record satisfies the RSTACK test criteria but is not a delimiter, it can be
deleted from or not selected for printing but still causes report separation.
A29247-X4-X-8-7672
Definition(s)
NONE
Specifies that report delimiters are not to be printed. For DELIMITER=NO, no page
is printed. If the report is being printed in duplex mode, report delimiters are printed
on a single-sided duplex output page. The parameter BOTH in duplex is treated as
BIN.
The default is NONE.
test-exp
Defines test expression for end-of-report conditions for either change mode or con-
stant criteria. The format and syntax of a test-exp are defined in the "Test expres-
sion definition" section. If a test-exp is satisfied, the record specifies an end-of-
report condition.
There is no default.
RSTACK Command
163
Advertisement
Table of Contents
