Compensating Manually For Clogged Jets - Oce CS 5050 User Manual

For severely clogged cartridges, completely clean the jet plate
Note:
thoroughly by immersing the cartridge jet plate into the ultrasonic cleaner
for 30-40 seconds. As a final attempt, try immersing the jet plate into
boiling water for 10-15 seconds.
After cleaning, reinstall the cartridge.
5
Select
6 Utility Menu
water/chemicals from the jets.
Press
7 Prev. Option
Press
8 OK
Rerun the prime pattern to verify whether the jet is cleared of ink clog.
9
Try to eliminate all gaps in the "stair step" pattern prior to starting your print
job.
If the printed results remain unsatisfactory, run the test several more times.

Compensating manually for clogged jets

In addition to the prime pattern, you can also print a jet status list which
identifies the number of individual clogged jets for each colour. This enables
you to manually enter the jet numbers (by cartridge colour) to initiate
compensation for the clogged jets. The jet compensation data is stored on the
cartridge chip.
To print the manual jet compensation list
From the main menu, select
1
Select
2 Open Jet Menu
shows the current jet compensation by number for each cartridge.
Manual jet compensation list
Y:
M:
C:
K:
94 Océ CS 5050/5070 User Manual
/
Service Menu
to change the option '10 %' to '100 %'.
to start printing.
Utility Menu
/
Print Jet list
None
1, 3, 10
None
10, 21, 30, 128
/ /
Diagnostics Colour Test
/
Service Menu
. In the example below, the jet status list
to clear
/ .
Calibration Menu