Setting Auto-Load Delay; Selecting Auto-Cut - Oce CS 5050 User Manual

0.59"(15mm)
0.59"(15mm)
0.59"(15mm)
[24] Roll sheet normal margins and expanded margins
To set margins
Press
1 Setup/Paper Option/Margins
Choose
2
Press
3 OK

Setting auto-load delay

Auto-load delay is the time lapse between the moment the printer senses the
presence of the media and when it actually starts feeding the media. This gives
you time to reposition the media manually if necessary. The default is 6
seconds, selectable from a range of 1-12 seconds.
To set auto-load delay
Press
1 Setup/Paper Option/Auto-load delay.
Choose the delay time.
2
Press
3 OK
Only stored in memory in combination with a user-defined setting.
Note:

Selecting auto-cut

With the
the media when printing completes. To ensure that the image is dry before
cutting, turn on the dryer and/or specify a dry time. You can also select to cut
the media manually from the printer control panel at any time.
Auto-cut is disabled when the paper feed option is set to
Note:
60 Océ CS 5050/5070 User Manual
0.59"(15mm
or
Normal Expanded
.
.
option activated (by default), the printer automatically cuts
Auto-cut
0.197"(5mm)
0.197"(5mm)
0.197"(5mm)
.
.
0.197"(5mm
.
"take-up"