Applying The Ink Limit; Printing An Hp-Gl/2 Test File - Oce CS 5050 User Manual

To set the "nesting wait time"
From the main menu, press
1
Select the
2
Choose the nest time (30 seconds, 1 minute, 2 minutes)
3
Press
4 OK

Applying the ink limit

The printer can limit the amount of ink laid down when printing polygon fills
and wide vectors. This prevents bleeding when you print on inexpensive inkjet
media. The default setting is "on". If you are printing on high quality media,
turn off this setting.
To apply the ink limit
From the main menu, press
1
Choose
2
Press
3 OK

Printing an HP-GL/2 test file

The printer's memory contains an HP-GL/2 test file to assist in diagnosing
potential problems. The printed colours in this test file are the same RGB
values defined in AutoCAD. Turn off the "ink limit" setting to get AutoCAD
colours on high quality media.
To print the test file
From the main menu, press
70 Océ CS 5050/5070 User Manual
menu.
Nest Time
.
.
On
.
/
Setup menu HP-GL/2 menu/Nesting
/
Setup menu HP-GL/2 menu/Ink limit
/
Utility menu Service menu/Test print
.
.
.