Cleaning The Slide Shaft; Cleaning The Encoder Strip - Oce CS 5050 User Manual

Return the sled into the service station. You will need to push down on the tab
4
to insert the sled completely into the base of the service station. The tab is
located on the left side of the sled when it is installed in the base, and must go
through the hole provided in the base.
[31] Replacing the sled
Reattach the spring to the sled.
5
Replace the service station into the printer. Ensure that the locking tab is snaps
6
into place.

Cleaning the slide shaft

The slide shaft requires regular cleaning to prevent the deterioration of image
quality and possibly a "carriage axis failure".
To clean the slide shaft
Raise the printer cover.
1
With a lint-free cloth moistened with isopropyl alcohol, gently clean the entire
2
slide shaft, both the top and bottom.
To clean the slide shaft area above the service station, press
3
Access Cartridges
After cleaning the area above the service station, press
4
return the carriage into the service station.
Close the cover.
5

Cleaning the encoder strip

The encoder strip is an essential part of the printer. If it becomes dirty, it can
cause various image quality problems. Clean regularly to maintain good image
quality.
84 Océ CS 5050/5070 User Manual
to move the carriage out of the way.
Utility Menu/
Access Cartridges
to