Oce CS 5050 User Manual page 22

Since media cores can be narrower than the media, position the media guide at
3
3 mm (1/8") from the end of the core and lock it into place.
Press
4 Feed Media
to come to the centre of the take-up roll.
[4] Locking the take-up roll
Using at least three pieces of tape, attach the leading edge of the media to the
5
take-up roll at the left, right, and centre of the core.
As printing progresses, the media loops down to the front of the take-up core
6
until the sensor detects it on the printer stand leg. The take-up rolls then
activate to roll the media.
Be sure not to block the sensor!
Note:
[5] Sensors on the printer stand
To set the take-up mode
Press
1 Setup
Press
2 OK
22 Océ CS 5050/5070 User Manual
/ to advance enough media to allow its leading edge
Forward
/ , then
Paper Option
. This enables the take-up roll and disables the cutter.
/
Supply Type Take-up
.