Loading Media; Using The Power Media Feed And Take-Up System - Oce CS 5050 User Manual

Loading media

You can use either roll media or cut sheets. The printer is set for roll media as
its default. To ensure straight paper loading and avoid skewing, hold the media
parallel to the platen line. Use the loading lines on the platen as a guide. The
printer has sensors which detect the presence of media and activate the feed
and take-up mechanisms.
The roll media core must have an inside diameter of 5 cm and a maximum
outside diameter of 15 cm (about 6 inches). If your media has an inside
diameter of 8 cm, use the core adapter provided. If you want to store prints on
the take-up roll, you will need to have extra cores available.
Caution:
60" (1,52 m) wide. The media roll may be heavy, so have someone help you
to load it. Before printing, check that you have a take-up roll core available
that is the same width as the media roll core you are loading.
Attention:
damaged part of the roll prior to loading, to prevent the media from
jamming in the printer. Load only media with an edge that is perfectly
horizontal into the printer. Make sure not to leave fingerprints on the
printing side of glossy media paper.

Using the power media feed and take-up system

The power media feed and take-up system facilitates long, unattended print
jobs by automatically unwinding and rewinding media as prints are generated.
It includes a feed roll, a take-up roll, and sensors which prevent media from
touching the floor.
When the unit is first switched on, the feeder may turn for a few seconds. If the
take-up turns, it indicates that the sensor is blocked. Clear anything blocking
the sensor before proceeding.
20 Océ CS 5050/5070 User Manual
The Océ CS 5050/5070 printers (60" version) can use media up to
If your roll media has wrinkled or damaged edges, cut off the