Calibrating The Paper Axis - Oce CS 5050 User Manual

Calibrating the paper axis

External factors such as room temperature, storage temperature, and humidity
can have a deforming effect on media. A paper axis calibration corrects minor
paper length fluctuations, and carried out using a precision ruler at least 33
inches (838.2 mm) long.
To print the paper axis test
Load the media that you want to use. Check that the length is at least 36 inches
1
(91 cm) long.
Press
2 Utility/Calibration/Paper Axis Test
Remove the media from the printer and measure the distance between the
3
witness marks. The distance between the marks should be exactly 838.2 mm
(33.00 ").
If the distance between the marks is different from that shown on the display,
4
press
Paper Axis
Press
The OGSL software can convert units from inches to metric, and vice
Note:
versa. See your software documentation for instructions.
Getting started
to enter the value of the distance you have just measured.
.
OK
. The printer prints two marks.
39