Remove the cartridge from the carriage by gently pulling the top edge toward
3
you, then lifting it out of the carriage. Leave the tube fitting attached to the
cartridge to avoid leaking.
[25] Leaving the tube fitting attached to the cartridge
Wipe any ink from the fitting using a lint-free cloth.
4
Store the cartridge in the cartridge garage to keep it ready for future use.
5
Repeat the previous steps for the remaining cartridges.
6
Attention:
side with the flex contacts facing up. This prevents ink from leaking out
either from the top opening or from the bottom jet area.
flex contact area of the cartridge
Removing the reservoirs
To remove the reservoirs
Remove all ink cartridges before removing the ink reservoirs.
1
Open the left front cover to access the reservoirs. Leave on the reservoirs caps.
2
Disconnect the quick-connect fitting for each reservoir, noting the colour of the
3
fitting to which it was connected.
Slide each reservoir forward to remove it from the printer.
4
Store the reservoirs away from direct sunlight, in an environment similar to
5
that of the printer.
Replace with new reservoirs.
6
Fill the reservoirs with the appropriate ink and attach to the other set of
7
quick-connect fittings (not used for the previous type of ink).
74
Océ CS 5050/5070 User Manual
When setting down a cartridge filled with ink, place it on its front
.
Do not touch the