Oce CS 5050 User Manual page 83

To replace the service station wipers
Perform the procedure described in 'Cleaning the service station' on page 81.
1
Carefully pull the wiper straight up until it comes completely off of the wiper
2
post, as shown below.
[29] Removing a wiper
Clean the post and the surrounding area. Use cotton swabs to clean small
3
spaces.
Carefully insert the new wiper into the post. Ensure that you insert each wiper
4
completely into the post, and that all four wipers are equal in height.
Install the service station back into the printer. Ensure that the locking tab
5
snaps into place.
To replace the service station wiper post
Release the spring on the bottom of the service station where it is connected to
1
the inner assembly (sled). Remove the sled from the base of the service station.
[30] Removing the sled
Locate the broken post and pull it straight out.
2
Insert the new post with wiper and spring into the sled. Continue pressing on
3
the post until the retaining locks on the post protrude from the bottom of the
sled.
Printer maintenance and storage 83