Half-Fold Position - Oce cm3522 User Manual

Utility mode
– If more adjustment is necessary, repeat steps 5 through 8.
Note
Set the value by mm. Refer to the conversion rate below.
1 inch = 25.4 mm
11.8.2

Half-Fold Position

The folding position when printing with the "Half-Fold" setting can be adjusted for each paper size and for
each paper type.
Note
[Half-Fold Position] appears if optional finisher 9355 is installed or optional finisher 9356 is installed with
the saddle stitcher attached.
If the angle of the center folding position must be adjusted, contact your service representative.
!
Detail
For details on the "Center Staple & Fold" setting, refer to
Staple" and "Half-Fold" setting / "Center Staple & Fold" setting)" on page
0 Before making any adjustments, use the "Half-Fold" setting to print a single sample copy. Perform the
adjustment while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
Settings screen" on page
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [2 Half-Fold Position].
The Half-Fold Position screen appears.
Océ cm3522/cm2522
11-35.
Finisher 9356 + Saddle stitcher
"Binding copies at the center ("Center
2-72.
"Displaying the Administrator
11
11-51