Oce cm3522 User Manual page 494

Utility mode
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [7 Punch Regist Loop Size Adjustment].
The Punch Regist Loop Size Adjustment screen appears.
6
Check the angle of the punched holes.
– If the punched holes are angled, touch [+] to change the adjustment. If the angle cannot be adjusted
by touching [+] or if the paper is wrinkled, touch [-] to change the adjustment.
– Each time [+] or [-] is touched, the value is increased or decreased by one increment.
– A range between -4 mm and 4 mm is available for setting.
7
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The angle of the punched holes is adjusted.
If no adjustment of the angle of the punched holes was necessary in step 6, this completes the
procedure.
8
Use a Punch setting to print another sample copy.
9
Check the print result.
– Check that the angle of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 and 7.
Note
Set the value by mm. Refer to the conversion rate below.
1 inch = 25.4 mm
Océ cm3522/cm2522
11
11-55