Utility mode
11.8
Finisher Adjustment
11.8.1
Center Staple Position Adjustment
The stapling position when printing with the "Center Staple & Fold" setting can be adjusted for each paper
size.
Note
[Center Staple Position Adjustment] appears if optional finisher 9355 is installed or optional Finisher
9356 is installed with the Saddle stitcher attached.
If the angle of the staple must be adjusted, contact your service representative.
!
Detail
For details on the "Center Staple & Fold" setting, refer to
Staple" and "Half-Fold" setting / "Center Staple & Fold" setting)" on page
For the procedure on adjusting the center folding position, refer to
page
11-51.
0
Adjust the center folding position before adjusting the center stapling position.
0
Before making any adjustments, use the "Center Staple & Fold" setting to print a single sample copy.
Perform the adjustment while checking the sample that was created.
1
Display the Administrator Settings screen.
–
For details on displaying the Administrator Settings screen, refer to
Settings screen" on page
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [1 Center Staple Position].
The Center Staple Position screen appears.
Océ cm3522/cm2522
11-35.
Finisher 9356 + Saddle stitcher
"Binding copies at the center ("Center
2-72.
"Half-Fold Position" on
"Displaying the Administrator
11
11-49