Oce cm3522 User Manual page 491

Utility mode
– If the saddle stitcher is installed on optional finisher 9356, touch buttons for the paper size and for
the paper type.
– If the paper size to be adjusted is not displayed, touch [↑] and [↓] until the desired paper size is
displayed.
6
Compare the width of the left pages of the copy sample with the width of the right pages to check for
the center of the paper.
– If the folding position is too far to the left of the center of the paper, touch [+] to increase the
adjustment.
– Each time [+] or [-] is touched, the value is increased or decreased by one increment.
– With Finisher 9356, a range between -10 and 10 is available for setting.
– With Finisher 9355, a range between -7 mm and 7 mm
is available for setting.
– If the folding position is too far to the right of the
center of the paper, touch [-] to reduce the
adjustment.
7
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The center folding position is adjusted.
If the folding position was at the center of the paper in step 6, this completes the procedure.
8
Use the "Half-Fold" setting to print another sample copy.
9
Check the print result.
– Check that the folding position is adjusted to the center of the paper.
Océ cm3522/cm2522
Finisher 9355
11
11-52