Oce cm3522 User Manual page 79

Basic copy operations
3
Press the [Start] key.
After the original has been scanned, the following message appears.
– Load the next batch of the original, and then press the [Start] key.
– If the "Separate Scan Output Method" parameter is set to "Batch Print", touch [Finish] in the
following screen, which appears while the original is scanned with the ADF, to continue to step 5.
– If the original cannot be loaded into the ADF, place it on the original glass. For details on the types
of originals that can be loaded into the ADF, refer to
– To change the scanning settings, touch [Change Setting]. For details on changing the scanning
settings, refer to
– The buttons that appear in the screen for changing the settings differ depending on the specified
settings. Settings for the following can be changed.
1-Sided/2-Sided, Binding Position, Zoom, Frame Erase, Center Erase, Original Size
– To cancel changes to the settings, touch [Cancel].
– The amount of memory available can be checked beside "Memory" in the lower-left corner of the
screen.
To delete the image data, press the [Stop] key, and then delete the job. For details, refer to
"Temporarily stopping scanning/printing" on page
Océ cm3522/cm2522
"Changing scan settings for each original" on page
"Originals" on page 6-19.
2-26.
2-78.
2
2-10