Oce cm3522 User Manual page 267

Copy paper/originals
4
Touch [Custom Size].
The Custom Size screen appears.
5
Type in the length (X) and width (Y) of the paper.
– Make sure that [X] is selected, touch [´] to switch between the integer and the fraction, and then
touch [–] and [+] to type in the length of side X. (5-1/2 inch to 18 inch)
– Make sure that [Y] is selected, touch [´] to switch between the integer and the fraction, and then
touch [–] and [+] to type in the length of side Y. (3-9/16 inch to 12-1/4 inch)
– If a decimal value is displayed in the Custom Size screen, use the keypad to type in the setting. For
details on switching between decimal and fraction values, refer to
page
– If a decimal value is displayed in the screen and the specified value is outside the allowable range,
the message "Input Error" appears. Type a value within the allowable range. If the value was
incorrectly entered, press the [C] (clear) key to erase the value, and then specify the correct value.
To cancel changes to the settings, touch [Cancel].
Can paper sizes be stored?
?
% Five non-standard paper sizes can be stored.
% To recall a stored paper size, touch the corresponding memory key.
% The names "memory1" through "memory5" can be changed. For details on changing the names,
refer to
% For details on storing paper sizes, refer to
settings)" on page
6
Touch [OK], and then touch [OK] in the next two screens that appear.
The Basic screen appears again.
Océ cm3522/cm2522
11-15.
"Storing a non-standard paper size (Custom Size settings)" on page
6-11.
"System Settings" on
"Storing a non-standard paper size (Custom Size
6
6-11.
6-10