Leading Edge Adjustment (Duplex Side 2) - Oce cm3522 User Manual

Utility mode
11.7.3

Leading Edge Adjustment (Duplex Side 2)

The starting print position at the leading edge for the second side during automatic double-sided copying
with each type of paper (with respect to the paper feed direction) can be adjusted.
0 The starting print position is adjusted during manufacturing of the machine. Normally, the starting print
position will not need to be adjusted.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
Settings screen" on page
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [2 Printer Adjustment].
The Printer Adjustment screen appears.
5
Touch [3 Leading Edge Adjustment (Duplex Side 2)].
The Leading Edge Adjustment (Duplex Side 2) screen appears.
6
Touch the button for the paper type to be set.
7
Press the [Start] key.
– Only paper loaded into the bypass tray can be used.
A test pattern is printed.
8
Check that the distance from the starting print position of the test pattern to the edge of the paper (c)
is 4.2 mm.
– If the distance is less than 4.2 mm, touch [+] to increase the adjustment (between 0.2 mm and 3.0
mm).
– If the distance is more than 4.2 mm, touch [-] to reduce the adjustment (between -0.2 mm and -3.0
mm).
Océ cm3522/cm2522
11-35.
"Displaying the Administrator
11
11-44