Setting The Key Repeat Start/Interval Time Functions - Oce cm3522 User Manual

Additional copy operations
The Touch Panel Adjustment. screen appears.
Why does the machine not respond when [Touch
?
Panel Adjustment.] is touched?
The touch sensors are not aligned on the touch panel.
% Press the [1] key in the keypad.
3
Touch the four check points [+], making sure that a sound is produced with each.
– The check points [+] can be touched in any order.
– To reset the adjustment, press the [C] (clear) key, and then touch the four check points [+].
If the check points have been touched correctly, the indicator on the [Start] key lights up in blue.
4
Press the [Start] key.
The touch panel is adjusted, and the Accessibility Setting screen appears again.
5
Touch [Close] or press the [Accessibility] key.
The Basic screen appears again.
Note
If the touch panel cannot be adjusted, contact the service representative.
!
Detail
To cancel the touch panel adjustment, press the [Stop] key or the [Reset] key.
3.7.3

Setting the Key Repeat Start/Interval Time functions

The length of time until the value begins to change after a touch panel button is held down and the length of
time for the value to change to the next number can be specified.
0 The settings specified for the Key Repeat Start/Interval Time functions are only applied in the Enlarge
Display mode.
1
Display the Accessibility Setting screen.
– For details on displaying the Accessibility Setting screen, refer to
Setting screen" on page
Océ cm3522/cm2522
3-19.
"Displaying the Accessibility
3
3-20