Centering (Duplex 2Nd Side) - Oce cm3522 User Manual

Utility mode
– Each time [+] or [-] is touched, the value is increased
or decreased by one increment.
9
Press the [Start] key.
The adjusted test pattern is printed.
10
Check the distance from the starting print position of the test pattern to the edge of the paper.
– Check that the distance has been adjusted to 4.2 mm.
– If more adjustment is necessary, repeat steps 8 and 9.
– To adjust the print position for a different paper type, return to step 6.
11
Touch [OK].
The print position is adjusted.
Note
Set the value by mm. Refer to the conversion rate below.
1 inch = 25.4 mm
11.7.4

Centering (Duplex 2nd Side)

The starting print position at the left edge of the paper for the second side during automatic double-sided
copying for each paper tray can be adjusted.
0 The starting print position is adjusted during manufacturing of the machine. Normally, the starting print
position will not need to be adjusted.
0 Only 8-1/2 × 11 v paper can be used to adjust the bypass tray.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
Settings screen" on page
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [2 Printer Adjustment].
The Printer Adjustment screen appears.
5
Touch [4 Centering (Duplex 2nd Side)].
The Centering (Duplex 2nd Side) screen appears.
Océ cm3522/cm2522
11-35.
c: 4.2 mm
"Displaying the Administrator
11
c
11-45