Installing Or Replacing The Rtm Isdn Card; Collaboration Server (Rmx) 4000 - Polycom 4000 Hardware Manual

RealPresence®Collaboration Server 4000 Hardware Guide
 Port usage is re-calculated and the Port Gauges and Video/Voice Port Configuration are updated
When the power on cycle of the MPMx/MPMRx card is completed, the blue HS LEDs will turn OFF.
The green RDY LED on the MPMx/MPMRx card switches on and remains lit.

Installing or Replacing the RTM ISDN Card

The RTM ISDN card must be seated opposite to an MPMx/MPMRx card located in the top slot on the front
of the RMX.
Removing the RTM LAN or Existing ISDN Card from the RealPresence

Collaboration Server (RMX) 4000

Carry out the following procedures to remove a RTM LAN or existing ISDN card, or install a new or
replacement RTM ISDN card on the RMX 4000.
To remove an RTM LAN or existing ISDN card:
1 Ensure that the power switch on the RMX 4000 is turned OFF (O).
2 Remove the RTM LAN or RTM ISDN card by unscrewing the captive screws that fasten the card to
the RMX. When removing a card, use the metal ejector levers to pull the RTM LAN or RTM ISDN
card out of its slot from the backplane.
3 Slide out the RTM LAN or RTM ISDN card.
To install a new or replacement RTM ISDN card:
1 On the RTM ISDN card move the ejector levers to their fully open position.
2 Slide the new RTM ISDN card into its slot.
An RTM ISDN card must connect directly to an MPMx/MPMRx card in the opposite facing front slot.
Polycom, Inc. 65