Installing Or Replacing The Rtm Isdn Card; Removing The Blank Cover; Removing An Existing Card Rtm Isdn Card; Installing A New Or Replacement Rtm Isdn Card - Polycom Collaboration Server (RMX) 2000 Hardware Manual

RealPresence Collaboration Server (RMX) 2000 Hardware Guide

Installing or Replacing the RTM ISDN Card

As a first installation, the RTM ISDN card must be installed in the top slot of the RMX
chassis. The RTM ISDN card must be seated opposite to an MPM+/MPMx card located in
the top slot on the front of the RMX.
Prior to adding the RTM ISDN card you must have your ISDN product license available. For
more information see, RealPresence Collaboration Server 1500/2000/4000 Getting Started Guide,
"Procedure 2: Product Registration" on page 2-28.

Removing the Blank Cover

For details, see "Removing the Blank Cover from the Rear Panel" on page 1-35.

Removing an Existing Card RTM ISDN Card

1
2
3

Installing a New or Replacement RTM ISDN Card

1
2
An RTM ISDN card must connect directly to an MPM+/MPMx card in the opposite facing front slot.
3
4
Tighten the captive screws on each side of the rear panel of the card, securing the RTM
ISDN card to the RMX.
1-36
Ensure that the power switch on the RMX 2000 is turned OFF (O).
Unscrew the captive screws that fasten the card to the MCU. Use the metal ejector
levers to pull the card out of its slot from the backplane.
Slide out the RTM ISDN card.
On the new RTM ISDN card move the ejector levers to their fully open position.
Slide in the RTM ISDN card in the RMX slot.
Ejector Lever Captive Screw
Push the card into the slot until the ejector levers touch the front edge of the card cage.
Push the ejector levers to their fully closed position.
Polycom, Inc.